Crown XLS 1000 2-Channel Power Amplifier

Features:

• XLS High Performance, Lightweight Class D amp weighs less than 11 lbs.
• Integrated PureBand™ Crossover System for better performance and control
• Peakx™ Limiters provide maximum output while protecting your speakers
• XLR, 1/4", RCA inputs provide outstanding flexibility
• Efficient forced-air fans prevent excessive thermal build up
• Electronically balanced XLR inputs; touch proof binding post and Speakon® outputs
• Precision detented level controls, power switch, power LED, and six LEDs which indicate signal, clip and fault for each channel
• Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications

Power

• Stereo, 2 ohms (per ch.):  550W
• Stereo, 4 ohms (per ch.):  350W
• Stereo, 8 ohms (per ch.):  215W
• Bridge-Mono, 8 ohms:  700W
• Bridge-Mono, 4 ohms:  1100W

Specifications

• Total Harmonic Distortion (THD):  < 0.5%
• Intermodulation Distortion (IMD):  (60Hz and 7kHz at 4:1)
  From fullrated output to -30dB:  <0.3%
• Damping Factor (8 ohm):  10 Hz to 400 Hz: > 200
• Crosstalk (below rated 8O power):
  • At 1 kHz:  > 85dB
  • At 20 kHz:  >55dB
• Input Impedance (nominal):  20 kO balanced, 10 kO unbalanced
• Load Impedance:
  • 2 to 8 ohms per channel in Stereo
  • 4 to 8 ohms in Bridge Mono
• AC Line Voltage and Frequency ConfigurationsAvailable (± 10%):
  • 120 VAC60 Hz
  • 100 VAC 50/60 Hz
  • 220 and 240 VAC 50 Hz
• Ventilation:  Flow-through ventilation from front to back
• Cooling:  Inteal heat sinks with forced-air cooling for rapid, uniform heat dissipation
• Air Volume Requirements (per minute per unit):  80.15 ft³ (2.27 m³)
• Integrated Processing:
  • PureBand™ Crossover System
  • Crossover Filter:  Linkwitz-Riley 24dB per Octave
  • Crossover Frequency Range:  50 HZ - 3kHz
  • Crossover Mode:  Crossover (CH1= LPF, CH2=HPF), Low Pass (both channels LPF), High Pass (both channels HPF),
  • Bridge (LPF or HPF).
  • Peakx™ limiters:  Channel independent clip limiter designed to provide maximum output while protecting your loudspeakers
• Input/Output:
  • Input Connectors:  XLR (one per channel), 1/4-Inch (oneper channel), and RCA (one per channel). 1/4-Inch connectors can be as loop-thrus to distribute signal to additional amplifiers.
  • Output Connectors:  Two 4-Pole Speakon® Output Connectors accept 2-pole or 4-poleSpeakon® connectors. The top Speakon connector is wired for both channels so it can be for bridge mono wiring or for stereo wiring of two speakers to a single Speakon connector.
  • One pair of back-panel binding posts per channel; accepts banana plugs or bare wire. (European models do not accept banana plugs.)
• Construction:  8.12" depth
• Dimensions (H x W x D):  3.5" x 19" x 7.7"
• Weight (Net, Shipping):  8.6 lbs, 13.6 lbs